JR Connector PRESS Parts

Share / Post your creations
Post Reply
User avatar
chuckphd53
Moderator
Moderator
Posts: 106
Joined: Fri Mar 20, 2020 3:45 pm

JR Connector PRESS Parts

Post by chuckphd53 »

These are capture housings to allow you to compress the sidecar JR connector when making proto boards ie. JRIDE as an example..

Simply use these two parts to capture the JR connector, then using a small vise slowly compress until the parts are seated properly.

Make this out of PLA ( preferred ) using a layer height of .250 mm
I used 3 top and bottom layers
and 4 perimeter shell outlines thickness
infill of 15% is ok for PLA

Image

https://www.pcjribm.com/pcjrfiles/connpressprod.stl
“I never commit to memory anything that can easily be looked up in a book.” (AE)

Post Reply